Digilent 410-316 Nexys Video Artix-7 Development Board

The Nexys Video FPGA Board features a large, high-capacity Artix-7 FPGA device, generous external memories, high-speed digital video ports and a 24-bit audio codec. It is perfectly suited for audio and video processing applications. Compatible with ISE® toolset and the Vivado® Design Suite. It is also supported under the free WebPACK™ license.

• 215360 logic cells in 33650 slices (each slice contains 4 x 6-input LUTs and 8 x flip-flops)
• 13Mbit Fast Block RAM
• 10 x Clock Management Tiles, each with a phase-locked loop (PLL)
• 740 x DSP slices
• Internal clock speeds exceeding 450MHz
• On-chip Analogue-to-Digital Converter (XADC)
• Up to 3.75Gbps GTP transceivers

• MT41K256M16HA-187E 512MiB DDR3 SDRAM
• S25FL256S 32MiB Quad-SPI Serial Flash memory
• 24AA025E48 EEPROM for Ethernet node MAC address
• ADAU1761 SigmaDSP stereo audio codec
• HDMI output connector
• HDMI input connector
• Programmable over JTAG, Quad-SPI or USB
• 0.91in 128 x 32pixel OLED display
• FPGA Programming-Done LED
• 8 x User LEDs
• 5 x User Pushbuttons
• 8 x User Slide-Switches
• MicroUSB (JTAG) connector for USB programming
• USB-UART Bridge via microUSB socket
• USB-A HID Host socket for mice, keyboards and memory sticks
• DisplayPort output mDP connector
• 160-pin LPC FMC connector
• RJ45 socket for 10/100/1000 Ethernet connection
• 3.5mm jack socket for mono microphone In
• 3.5mm jack socket for stereo audio Line In
• 3.5mm jack socket for stereo audio Line Out
• 3.5mm jack socket for stereo headphone Out
• microSD card slot
• 3 x Standard Pmod 2 x 6-pin connectors
• Dual Analogue/Digital XADC Pmod 2 x 6-pin connector
• Powered from barrel jack socket or external +12Vdc header

Hardshell plastic case with protective foam, USB cable

An FPGA is a semiconductor device consisting of a matrix of Configurable Logic Blocks (CLBs) connected through programmable interconnects. The user determines these interconnections by programming SRAM. A CLB can be simple (AND, OR gates, etc) or complex (a block of RAM). The FPGA allows changes to be made to a design even after the device is soldered into a PCB.