John Drummond, LED Voltage Tester, 500V ac/dc, Mains Powered CAT IV, CAT III, MTL20

RS庫存編號:: 706-8577
製造零件編號:: MTL20
製造商:: John Drummond

John Drummond, LED Voltage Tester, 500V ac/dc, Mains Powered CAT IV, CAT III, MTL20

小計（1 件）*

TWD4,086.00

(不含稅)

TWD4,290.30

訂單超過 $1,300.00 免費送貨

有庫存

2 件準備從其他地點送貨
加上 8 件從 2026年4月03日起發貨

**需要更多嗎？**輸入您需要的數量，然後按一下「查看送貨日期」以查詢更多庫存和送貨詳細資訊。

單位	每單位
1 +	TWD4,086.00

* 參考價格

RS庫存編號:: 706-8577
製造零件編號:: MTL20
製造商:: John Drummond

規格

產品概覽和技術數據資料表

法例與合規

產品詳細資訊

透過選取一個或多個屬性來查找類似產品。

選取全部	屬性	值
	品牌	John Drummond
	Product Type	Voltage Tester
	Display Type	LED
	IP Rating	IP67
	Power Source	Mains
	Weight	350g
	Minimum Operating Temperature	-10°C
	Maximum Operating Temperature	55°C
	Maximum Voltage	500V ac/dc
	Hazardous Area Certification	No
	Width	112mm
	Standards/Approvals	BS EN 61326-1
	Length	213mm
	Height	72mm
	Safety Category Voltage	1000V
	Safety Category Level	CAT IV, CAT III

	選取全部
	品牌 John Drummond
	Product Type Voltage Tester
	Display Type LED
	IP Rating IP67
	Power Source Mains
	Weight 350g
	Minimum Operating Temperature -10°C
	Maximum Operating Temperature 55°C
	Maximum Voltage 500V ac/dc
	Hazardous Area Certification No
	Width 112mm
	Standards/Approvals BS EN 61326-1
	Length 213mm
	Height 72mm
	Safety Category Voltage 1000V
	Safety Category Level CAT IV, CAT III

不適用

COO (Country of Origin):: PH

Drummond Test Lamp MTL20

Bright LED indication of voltage between 50V and 500V AC/DC

Four distinct bands of illumination above 50, 100, 200 and 400V AC/DC with a 360o viewing angle even in bright sunlight

Identifies potentially lethal voltages at 50V and distinguishes between 110V, 230V and phase to phase voltages in 3 phase systems

Additional two button test allows the unit to draw a high current to differentiate between potentially hazardous phantom voltages and hazardous persistent voltages

Finger shields and insulated probe tips with only 4mm of exposed metal

Double insulated cable with white inner insulation gives a clear warning of abrasion and is heat and oil resistant

Meets the UK Health and Safety Executive guidance notes on electrician’s test lamp (GS38)

Complies with BS EN 61243-3 and BS EN 61010. CAT IV 600V, CAT III 1000V

No batteries required

Mains Voltage Indicators - Contact

Caution

Test lamps should be proved safe before and after use, by testing on a known live circuit, using the continuity tester, or through the Martindale PD690 proving unit.

Supplied with

Right angled probe tip, two straight tips and instructions