John Drummond, LED Voltage Tester, 500V ac/dc, Mains Powered CAT IV, CAT III, MTL10

RS庫存編號:: 706-8573
製造零件編號:: MTL10
製造商:: John Drummond

John Drummond, LED Voltage Tester, 500V ac/dc, Mains Powered CAT IV, CAT III, MTL10

小計（1 件）*

TWD3,508.00

(不含稅)

TWD3,683.40

訂單超過 $1,300.00 免費送貨

暫時缺貨

4 件從 2026年4月03日起裝運發貨
加上 8 件從 2026年5月01日起發貨

**需要更多嗎？**輸入您需要的數量，然後按一下「查看送貨日期」以查詢更多庫存和送貨詳細資訊。

單位	每單位
1 +	TWD3,508.00

* 參考價格

RS庫存編號:: 706-8573
製造零件編號:: MTL10
製造商:: John Drummond

規格

產品概覽和技術數據資料表

法例與合規

產品詳細資訊

透過選取一個或多個屬性來查找類似產品。

選取全部	屬性	值
	品牌	John Drummond
	Product Type	Voltage Tester
	Display Type	LED
	IP Rating	IP67
	Power Source	Mains
	Weight	320g
	Minimum Operating Temperature	-10°C
	Maximum Operating Temperature	55°C
	Maximum Voltage	500V ac/dc
	Width	112mm
	Standards/Approvals	BS EN 61326-1
	Hazardous Area Certification	No
	Height	72mm
	Length	213mm
	Safety Category Level	CAT IV, CAT III
	Safety Category Voltage	1000V

	選取全部
	品牌 John Drummond
	Product Type Voltage Tester
	Display Type LED
	IP Rating IP67
	Power Source Mains
	Weight 320g
	Minimum Operating Temperature -10°C
	Maximum Operating Temperature 55°C
	Maximum Voltage 500V ac/dc
	Width 112mm
	Standards/Approvals BS EN 61326-1
	Hazardous Area Certification No
	Height 72mm
	Length 213mm
	Safety Category Level CAT IV, CAT III
	Safety Category Voltage 1000V

不適用

COO (Country of Origin):: PH

Drummond Test Lamps MTL10

Bright LED indication of voltage between 50V and 500V AC/DC

Four distinct bands of illumination above 50, 100, 200 and 400V AC/DC with a 360o viewing angle even in bright sunlight

Identifies potentially lethal voltages at 50V and distinguishes between 110V, 230V and phase to phase voltages in 3 phase systems

Finger shields and insulated probe tips with only 4mm of exposed metal

Double insulated cable with white inner insulation gives a clear warning of abrasion and is heat and oil resistant

Meets the recommendations of the UK Health and Safety Executive in their guidance notes on the electrician’s test lamp (GS38)

Complies with BS EN 61243-3 and BS EN 61010. CAT IV 600V, CAT III 1000V

No batteries required

Mains Voltage Indicators - Contact

Caution

Test lamps should be proved safe before and after use, by testing on a known live circuit, using the continuity tester, or through the Martindale PD690 proving unit.

Supplied with

Carry case, right angled probe tip, two straight tips and instructions