Nexperia PCMF2USB3SZ 2-Element Uni-Directional ESD Protection Diode, 1500 W, 10-Pin WLCSP
- RS庫存編號:
- 153-0753
- 製造零件編號:
- PCMF2USB3SZ
- 製造商:
- Nexperia
此圖片僅供參考，請參閲產品詳細資訊及規格
暫時無法供應
我們無法確定此產品何時有貨，RS 預計將其從我們的產品目錄中移除。
- RS庫存編號:
- 153-0753
- 製造零件編號:
- PCMF2USB3SZ
- 製造商:
- Nexperia
規格
產品概覽和技術數據資料表
法例與合規
產品詳細資訊
透過選取一個或多個屬性來查找類似產品。
選取全部 | 屬性 | 值 |
|---|---|---|
| 品牌 | Nexperia | |
| Diode Configuration | Single | |
| Product Type | ESD Protection Diode | |
| Direction Type | Uni-Directional | |
| Minimum Breakdown Voltage Vbr | 6.45V | |
| Mount Type | Surface | |
| Package Type | WLCSP | |
| Maximum Reverse Stand-off Voltage Vwm | 5.8V | |
| Pin Count | 10 | |
| Peak Pulse Power Dissipation Pppm | 1500W | |
| Minimum Operating Temperature | -40°C | |
| Clamping Voltage VC | 10.5V | |
| Maximum Peak Pulse Current Ippm | 100A | |
| ESD Protection | Yes | |
| Test Current It | 1mA | |
| Number of Elements per Chip | 2 | |
| Maximum Operating Temperature | 85°C | |
| Height | 0.38mm | |
| Length | 1.62mm | |
| Width | 1.22mm | |
| Maximum Reverse Leakage Current | 100nA | |
| 選取全部 | ||
|---|---|---|
品牌 Nexperia | ||
Diode Configuration Single | ||
Product Type ESD Protection Diode | ||
Direction Type Uni-Directional | ||
Minimum Breakdown Voltage Vbr 6.45V | ||
Mount Type Surface | ||
Package Type WLCSP | ||
Maximum Reverse Stand-off Voltage Vwm 5.8V | ||
Pin Count 10 | ||
Peak Pulse Power Dissipation Pppm 1500W | ||
Minimum Operating Temperature -40°C | ||
Clamping Voltage VC 10.5V | ||
Maximum Peak Pulse Current Ippm 100A | ||
ESD Protection Yes | ||
Test Current It 1mA | ||
Number of Elements per Chip 2 | ||
Maximum Operating Temperature 85°C | ||
Height 0.38mm | ||
Length 1.62mm | ||
Width 1.22mm | ||
Maximum Reverse Leakage Current 100nA | ||
Common Mode filter for USB ports, No room for compromise, The most common Camera and display Interface used now for portable devices is the differential MIPI Interface running at RF frequencies. To allow operation at typical GSM/3G/LTE frequencies, a strong common-mode suppression over all bands and higher harmonics is needed. At the same time, a wide differential passband is needed to keep signal integrity. Since ESD can enter through gaps in the portable device, strong ESD protection is needed to avoid damage of the electronics or re-setting the system due to ESD strikes
Strong common-mode suppression > 14 dB in the range between 500 MHz and > 8 GHz
Wide passband > 2 GHz, ensuring signal integrity for all MIPI frequencies
ESD ruggedness > 15 kV contact, far exceeding IEC 61000-4-2 (8 kV contact)
Deep snap-back for optimized SoC protection against ESD strikes
Very thin package (0.5 mm max package height)
All LVDS signals needing a passband up to 2 GHz
相關連結
- Nexperia PCMF2USB3SZ 2-Element Uni-Directional ESD Protection Diode 10-Pin WLCSP
- Nexperia 2-Element Uni-Directional ESD Protection Diode, 5-Pin WLCSP
- Nexperia PESD1USB3SZ 2-Element Uni-Directional ESD Protection Diode, 5-Pin WLCSP
- Nexperia PCMF3USB3SZ 2-Element Uni-Directional ESD Protection Diode, 15-Pin WLCSP
- Nexperia PCMF3USB30Z 2-Element ESD Protection Diode, 15-Pin WLCSP
- Nexperia PCMF2HDMI2SZ 2-Element ESD Protection Diode, 10-Pin WLCSP
- STMicroelectronics 2-Element Uni-Directional ESD Protection Diode, 13-Pin WLCSP
- STMicroelectronics OCVPB21-13F6 2-Element Uni-Directional ESD Protection Diode, 13-Pin WLCSP