最近搜索

    Pico Technology TA Series TA041 Oscilloscope Probe, Active, Differential Type, 25MHz, 1:10, 1:100, 700V Max

    RS庫存編號:
    898-6744
    製造零件編號:
    TA041
    製造商:
    Pico Technology
    Pico Technology
    查看所有Oscilloscope Probes
    19 現貨庫存,可於6工作日發貨。
    Add to Basket
    單位

    已增加

    單價(不含稅) 個

    原價 TWD14,423.00

    您付款

    TWD12,156.00

    (不含稅)

    TWD12,763.80

    (含稅)

    單位Per unit
    1 +TWD12,156.00
    RS庫存編號:
    898-6744
    製造零件編號:
    TA041
    製造商:
    Pico Technology
    COO (Country of Origin):
    TW

    產品概覽和技術數據資料表


    法例與合規

    COO (Country of Origin):
    TW

    產品詳細資訊

    Pico Technology Oscilloscope Probe


    The Pico Technology TA041 oscilloscope probe is an active differential probe, suitable for high common-mode voltage measurement applications up to ±700V. It can be used with a signal speed of up to 25Hz. This differential probe extends the functionality of standard single-ended input oscilloscopes to allow a safe and accurate method of making high voltage differential measurements.

    By selecting attenuation ratio 1:10, this oscilloscope probe can measure signals below 70 V to get higher resolution and less noise. Or else, set the attenuation to 1:100.

    Features and Benefits


    Bandwidth is DC to 25MHz (–3dB)
    Attenuation ratio is 10:1/100:1
    Accuracy is ±2%
    Input impedance is 4Mohm ll5.5pF each side to ground
    Differential range is (10:1) ±70V (DC + peak AC) or 70VRMS
    Maximum differential is (100:1) ±700V (DC + peak AC) or 700VRMS
    Common mode range is ±700V (DC + peak AC) or 700VRMS (10:1 & 100:1)
    Absolute maximum voltage is ±1400V (DC + peak AC) or 1000VRMS (10:1 & 100:1)
    Swing is ±7V into 2kohm load
    Offset (typical) is <±5mV
    Noise (typical) is 0.7mVRMS
    Source impedance is 1ohm at 1kHz and 8ohm at 20kHz
    CMRR (typical) is 86dB at 50Hz and 66dB at 1MHz
    Ambient operating temperature ranges between -10°C and 40°C
    Power requirement 4xAA batteries or 6VDC/60mA mains adaptor or regulated 9VDC/40mA mains adaptor
    Input lead length 450 mm
    BNC lead length 950 mm
    Dimensions (LxWxH): 170x63x21 mm

    Applications


    This probe is designed for carrying out differential measurements between two points on the circuit under test. It can be found in:

    Safe measurement in power circuit
    Acquisition of low speed balanced differential signals found in serial communications buses
    Transients in switching power supplies, inverters and motor drives, electronic ballasts and CRT displays
    Signals in the milliV range from sensors and other instrumentation

    Certifications


    IEC-1010.1
    IEC-1010.2-031 CAT III
    Pollution Degree 2.


    規格

    屬性
    Probe TypeActive, Differential
    Attenuation1:10, 1:100
    Bandwidth25MHz
    Maximum Common Mode Input Voltage700V
    Connector TypeBNC
    Model Number pTA041
    Number of Probes2
    SeriesTA
    Safety Category700 V, CAT III ±700V
    19 現貨庫存,可於6工作日發貨。
    Add to Basket
    單位

    已增加

    單價(不含稅) 個

    原價 TWD14,423.00

    您付款

    TWD12,156.00

    (不含稅)

    TWD12,763.80

    (含稅)

    單位Per unit
    1 +TWD12,156.00