SICK Female 5 way M12 to Unterminated Unterminated Sensor Actuator Cable, 5 m

This sensor actuator cable connects M12-equipped sensors to equipment via flying leads for direct wiring in industrial systems. It is intended for sensor and actuator signal transmission in harsh environments where mechanical and chemical exposure occurs, offering a robust grey PVC outer sheath and a five-core conductor arrangement for straightforward integration into automation, electrical and mechanical installations.

• Rated for ≤125V to support low-voltage control circuits
• Five conductors with 0.34mm² cross-section for reliable signal carrying
• Ingress protection IP65/IP66K/IP67 allowing washdown and outdoor use
• Operating range −5°C to +80°C flexible during movement
• Current rating 4A to handle typical sensor loads
• Unshielded design reduces stiffness for tight routing

• Suitable for wiring proximity sensors in factory automation
• Ideal for connecting valve actuators on process equipment
• Used for linking conveyors’ detection heads to control panels
• Can be used for retrofit sensor installations in machinery
• Suitable for installations requiring M12 female to unterminated connection

One end has a 5-pin A-coded M12 female connector with angled orientation and screw termination

The recommended tightening torque for the locking nut is 0.6 Nm and an SW13 tool is suitable for assembly.

The cable diameter is 5.2mm and the minimum bending radius is greater than 10x diameter for flexing and greater than 5x diameter when stationary.

The connector housing is MADE from TPU, the locking nut is nickel-plated zinc die-cast and the seal uses FKM to enhance chemical resistance.