SKF Nitrile Rubber (NBR) Seal, 25 mm ID, 40 mm OD, 10 mm

查看所有Seals

小計（1 包，共 10 件）*

TWD457.00

(不含稅)

TWD479.80

(含稅)

Add to Basket
選擇或輸入數量
有庫存
  • 10 件準備從其他地點送貨
**需要更多嗎？**輸入您需要的數量，然後按一下「查看送貨日期」以查詢更多庫存和送貨詳細資訊。
單位
每單位
每包*
10 +TWD45.70TWD457.00

* 參考價格

RS庫存編號:
266-9040
製造零件編號:
25X40X10 HMSA10 RG
製造商:
SKF
透過選取一個或多個屬性來查找類似產品。
選取全部

品牌

SKF

Product Type

Seal

Seal Type

Rotary Shaft Seal

Thickness

10mm

Seal Material

Nitrile Rubber (NBR)

COO (Country of Origin):
CN

SKF Seal, 25mm Inside Diameter, 40mm Outside Diameter - 25X40X10 HMSA10 RG


This seal is a rotary shaft seal designed to separate rotating and stationary components and retain lubricants in rotating assemblies. It features a rubber outer circumference and an elastomeric primary sealing element to maintain oil or grease containment while limiting ingress of contaminants in industrial rotating equipment.

Features & Benefits


• Nitrile construction resists common oils and greases
• Garter spring maintains consistent lip contact under rotation
• Auxiliary non-contact lip improves contamination exclusion
• Accommodates minor misalignment during shaft operation

**Applications**


• Suitable for industrial motor and gearbox shafts
• Ideal for automation actuator rotary joints
• Used with electrical motor drive assemblies
• Can be used for centrifugal pump shaft Seals

What temperature range can it withstand in continuous service?


It operates from −40°C up to 100°C in normal use with short-term tolerance to 120°C.

How does it behave at higher shaft speeds?


It is rated for circumferential speeds up to 5.03 m/s and rotational speeds up to 3840 rev/min.

Is it compatible with pressurised housings?


It is intended for low differential pressure conditions and is specified for a 0.03 N/mm pressure differential.

What housing and shaft interfaces are required for correct fit?


The seal fits into a 40mm bore and runs on a 25mm shaft with a 10mm section width.

Are there related accessories to aid installation on worn shafts?


A speedi-sleeve accessory is referenced for use when shaft repair or undersize restoration is needed.

相關連結