Telemecanique Sensors ZCMD Series Limit Switch Body, 1 NO/1 NC, IP67, IP66, Zamak Housing, 50V ac, 3A

This limit switch body is designed to house and Interface mechanical switching elements for industrial control systems, providing a compact, sealed enclosure and an M12 conduit entry for electrical connection. It is intended for use where a small footprint and environmental protection are required, and is compatible with snap-action contact mechanisms for changeover switching in automation and machinery.

• Zamak construction provides robust mechanical protection • IP67 and IP66 ingress protection enables waterproof operation • Snap-action contact type ensures Rapid make/break switching • 1NO/1NC contact arrangement allows versatile signalling options • Rated for 50V AC and 50V DC at 3A supports low-voltage circuits • Operates between -25°C and 70°C for varied ambient conditions

• Suitable for position sensing on factory conveyors and Gates • Ideal for safety interlocks in electrical panels and enclosures • Used with pneumatic and hydraulic actuators for end-of-travel detection • Can be used for machine-tool limit detection in workshops • Used for retrofitting as a replacement component in control cabinets

It uses an M12 Terminal connector to simplify wiring and enable quick connection to standard sensor and actuator cabling.

The single normally open and normally closed contacts permit both signalling and safety circuits without additional relays for Basic control schemes.

Allowance should be MADE for a Compact body measuring 59mm in length and 30mm in width when planning installation space.

The unit is specified to function reliably down to -25°C and up to 70°C in operational environments.