Nexperia 74HC574D,653 8 Flip Flop IC 74HC, 3 State, 20-Pin SO
- RS庫存編號:
- 170-7983
- 製造零件編號:
- 74HC574D,653
- 製造商:
- Nexperia
暫時無法供應
我們無法確定此產品何時有貨，RS 預計將其從我們的產品目錄中移除。
- RS庫存編號:
- 170-7983
- 製造零件編號:
- 74HC574D,653
- 製造商:
- Nexperia
規格
產品概覽和技術數據資料表
法例與合規
產品詳細資訊
透過選取一個或多個屬性來查找類似產品。
選取全部 | 屬性 | 值 |
|---|---|---|
| 品牌 | Nexperia | |
| Product Type | Flip Flop IC | |
| Logic Family | 74HC | |
| Input Type | CMOS | |
| Output Type | 3 State | |
| Clock Frequency | 24MHz | |
| Polarity | Non-Inverting | |
| Mount Type | Surface | |
| Minimum Supply Voltage | 2V | |
| Package Type | SO | |
| Pin Count | 20 | |
| Maximum Supply Voltage | 6V | |
| Flip-Flop Type | D Flip-Flop | |
| Trigger Type | Positive Edge | |
| Minimum Operating Temperature | -40°C | |
| Maximum Propagation Delay Time @ CL | 38ns | |
| Maximum Operating Temperature | 125°C | |
| Number of Elements per Chip | 8 | |
| Standards/Approvals | No | |
| Length | 13mm | |
| Height | 2.45mm | |
| Automotive Standard | No | |
| 選取全部 | ||
|---|---|---|
品牌 Nexperia | ||
Product Type Flip Flop IC | ||
Logic Family 74HC | ||
Input Type CMOS | ||
Output Type 3 State | ||
Clock Frequency 24MHz | ||
Polarity Non-Inverting | ||
Mount Type Surface | ||
Minimum Supply Voltage 2V | ||
Package Type SO | ||
Pin Count 20 | ||
Maximum Supply Voltage 6V | ||
Flip-Flop Type D Flip-Flop | ||
Trigger Type Positive Edge | ||
Minimum Operating Temperature -40°C | ||
Maximum Propagation Delay Time @ CL 38ns | ||
Maximum Operating Temperature 125°C | ||
Number of Elements per Chip 8 | ||
Standards/Approvals No | ||
Length 13mm | ||
Height 2.45mm | ||
Automotive Standard No | ||
The 74HC574, 74HCT574 is an 8-bit positive-edge triggered D-type flip-flop with 3-state outputs. The device features a clock (CP) and output enable (OE) inputs. The flip-flops will store the state of their individual D-inputs that meet the set-up and hold time requirements on the LOW-to-HIGH clock (CP) transition. A HIGH on OE causes the outputs to assume a high-impedance OFF-state. Operation of the OE input does not affect the state of the flip-flops. Inputs include clamp diodes. This enables the use of current limiting resistors to interface inputs to voltages in excess of VCC.
Mixed 5 V and 3.3 V applications
Improved signal integrity with integrated termination resistors
High noise immunity
Flow through pin out for easy layout
Wide supply voltage range
Low propagation delay
Overvoltage tolerant input options
Integrated source termination resistor options
Bus hold options
Key applications
Frequency division
Controlled delays
Interface between asynchronous and synchronous systems