RS PRO V4178 Crimp Tool Crimp Tool for Coaxial Connector

• 456-431 - 50Ω version, Identified by its Green handles.

• 456-447 - 75Ω red-handled tool.

Both crimp tools feature cushioned handles for comfortable and safe operation.

• Made of high-quality steel to ensure durability and long life operation

• Ergonomically designed handles for comfortable and safe operation

• Ratchet release mechanism to clear miscrimps and obstructions

• Maintenance & repair

• Electrical Installations

• Cable assemblies

Un-insulated crimp tools are typically used for general applications, whereas the insulated crimp tools have been VDE tested up to 1000 V, designed for use where electrical current is present.

• Axles and other movable parts should be regularly lubricated.

• Lubrication* is recommended at least every 10,000 cycles whenever the tool is exposed to contaminants.

• Adjustment of the crimping die nests should also be checked. Readjustment of the pressure adjustment axle is necessary when the pre-load of the tool decreases significantly.

When a crimping tool is used on a terminal, two crimps take place at the same time. One is the electrical connection between the conductor and terminal. The other is the insulation crimp which provides strain relief against vibration and tension. It is important that the electrical connection is gas-tight without any voids between the wire strands and the terminal. If there any voids present, then corrosion can occur causing resistance and excessive heat which damages the electrical connection. Using a good quality crimping tool will ensure that a full, gas-tight crimp is produced preventing future deterioration of the electrical connection and insulation breakage.