GET Lighting Transformer, 230 → 240V ac, 11.4 → 11.6V ac
- RS庫存編號:
- 486-126
- 製造零件編號:
- GTRE105P
- 製造商:
- GET
不可供應
RS 不再對此產品進貨。
- RS庫存編號:
- 486-126
- 製造零件編號:
- GTRE105P
- 製造商:
- GET
規格
產品概覽和技術數據資料表
法例與合規
產品詳細資訊
透過選取一個或多個屬性來查找類似產品。
選取全部 | 屬性 | 值 |
|---|---|---|
| 品牌 | GET | |
| Primary Voltage Rating | 230 → 240V ac | |
| Secondary Voltage Rating | 11.4 → 11.6V ac | |
| Dimensions | 147 x 40 x 30 mm | |
| Length | 147 mm | |
| Width | 40 mm | |
| Depth | 30 mm | |
| Minimum Load Requirement | 35W | |
| Weight | 121 g | |
| Type | Electronic | |
| Dimming | Dimming | |
| Dimming Method | Trailing Edge | |
| Primary Current Rating | 8.8 | |
| Maximum Operating Frequency | 50Hz | |
| 選取全部 | ||
|---|---|---|
品牌 GET | ||
Primary Voltage Rating 230 → 240V ac | ||
Secondary Voltage Rating 11.4 → 11.6V ac | ||
Dimensions 147 x 40 x 30 mm | ||
Length 147 mm | ||
Width 40 mm | ||
Depth 30 mm | ||
Minimum Load Requirement 35W | ||
Weight 121 g | ||
Type Electronic | ||
Dimming Dimming | ||
Dimming Method Trailing Edge | ||
Primary Current Rating 8.8 | ||
Maximum Operating Frequency 50Hz | ||
- COO (Country of Origin):
- CN
Approvals
8888
Low Voltage Lighting Transformers
Dimming Methods (where applicable):
Leading Edge:
The control device is either a thyristor or triac which blocks power until they are switched on by the control signal. At that point the current flows almost instantaneously and continues to flow until the end of the half cycle of the mains waveform. When the signal reaches zero, the device turns off and no more current is passed until it is triggered again. Turning the power on and off in this manner averages out creating a constant intensity level and by altering the precise trigger point over a period of time the lamp can be dimmed.
Trailing Edge:
Since this method of dimming uses transistor technology it is not limited to just switching, therefore current can be controlled gradually. Transistors can be programmed to pass current at the start of each half cycle, and gradually switch off later. This will control the full amount of power reaching the lamp without the side effects of a step increase in current.
Leading Edge:
The control device is either a thyristor or triac which blocks power until they are switched on by the control signal. At that point the current flows almost instantaneously and continues to flow until the end of the half cycle of the mains waveform. When the signal reaches zero, the device turns off and no more current is passed until it is triggered again. Turning the power on and off in this manner averages out creating a constant intensity level and by altering the precise trigger point over a period of time the lamp can be dimmed.
Trailing Edge:
Since this method of dimming uses transistor technology it is not limited to just switching, therefore current can be controlled gradually. Transistors can be programmed to pass current at the start of each half cycle, and gradually switch off later. This will control the full amount of power reaching the lamp without the side effects of a step increase in current.