Vinculum VNC2 Debug Module

The VNC2 debug module is designed to provide connectivity between the Vinculum-II IDE development software and the debug interface pin on the FTDI Vinculum-II (VNC2) USB host controller device. The VNC2 debug module consists of a miniature board with a USB miniB connector, which provides USB connectivity to Vinculum-II IDE development tools running on a PC. The VNC2 debug module can be used to program and debug firmware running on the VNC2 device. The module connects to the VNC2 device via a 6-way, 2mm pitch, keyed, female connector. The V2DIPx-x, VNC2 based development modules are equipped with a compatible male connector to host the VNC2 debug module. Designers intending to use the module with their own VNC2 based hardware are required to have a similar compatible male connector on their hardware. Details on the debug interface and connectors are outlined in subsequent sections of this document.

One USB ’mini-B’ type socket to connect with a PC

On-board FTDI FT232R which provides conversion from USB to serial interface for VNC2 debug port

Low USB bandwidth consumption

USB 2.0 Full Speed compatible

UHCI/OHCI/EHCI host controller compatible

+5V power output to V2DIP-x module (if needed)

USB powered

Programming and debugging for VNC2 IC designs

Power and traffic indicator LEDs

6-way keyed connector to support FTDI’s range of V2DIPx-x development modules

-40 to +85℃ operating temperature range

單位	每單位
1 - 4	TWD649.00
5 +	TWD630.00

選取全部	屬性	值
	品牌	FTDI Chip
	Sub Type	Debugger
	Product Type	Chip Programming Adapter
	For Use With	Viniculum-II IDE
	Standards/Approvals	No

	選取全部
	品牌 FTDI Chip
	Sub Type Debugger
	Product Type Chip Programming Adapter
	For Use With Viniculum-II IDE
	Standards/Approvals No

FTDI Chip VNC2 DEBUG MODULE Chip Programming Adapter Debugger for Viniculum-II IDE

訂單超過 $1,300.00 免費送貨

Vinculum VNC2 Debug Module

相關連結