PR Electronics 3100 Series Isolating Signal Converter, Current Input, Current Output, 16.8 → 31.2V dc Supply,

3103 and 3108 type are for isolation and conversion of standard current signals.
Suitable for galvanic separation of analog current signals and elimination of ground loops and measurement of floating signals.

Repeater for 0-20mA
Response time < 7 ms
Splitter function: 1 in - 2 out (only 3108 type, stock-no. 796-7082)
Simple, no setup needed
Input is protected against overvoltage and polarity error
Inputs and outputs are floating and galvanically separated
Installation in ATEX Ex zone 2 / IECEx Zone 2 / FM division 2
Suitable for environments with high vibration stress, e.g. ships
Slimline housing of 6 mm

Re-calibration is not needed after changing the DIP-switch range settings. Just change the DIP-switch, cycle the power to the unit and obtain the new, pre-calibrated I/O range. HART programming is enabled for selected devices.

Devices can be mounted both vertically and horizontally with no air gap separation required. The devices snap onto a power rail or DIN rail and are easily detached by lifting the bottom lock.

Safe galvanic isolation of 2.5 kVAC provides high noise immunity and prevents ground loops for accurate delivery of the process signal to your control system.

A front LED indicates device status, e.g. an error in the set-up, sensor or hardware.

All terminals can withstand up to ±31.2 VDC and are protected against incorrect supply wiring to ensure safe, error-free installation.

PR Electronics DIN Rail Mounting