4D Systems Resistive Touch LCD Starter Kits with PICASO Processor for Use with Arduino
The range of resistive touch LCD Starter kits for Arduino available from 4D Systems provide everything needed by a user to easily interface between an Arduino (using its serial port + one GPIO pin) and the resistive touch LCD module, eliminating wiring hassles. The user can then quickly begin programming the 4D Systems display module through the Arduino. This display is a secondary display and does not replace the monitor or TV used to program the Arduino itself.
Powered from the Arduino the display module can be programmed and configured using 4D Systems Workshop4 software IDE (see datasheet for link to download). The LCD module is set up to receive a wide range of serial commands from the Arduino, for example, to display shapes, text, images, to play sounds and log data to the microSD card.
Features
4D-Labs PICASO processor Built-in extensive 4DGL graphics and system library functions Flash memory for user code Audio amplifier and loudspeaker micro-SD card socket 13 x GPIO pins I2C and UART serial communications Powered from Arduino
Package Contents
4D Arduino adapter Shield microSD card - 2GB or 4GB, model dependant uUSB-PA5 programming adapter Female to female 150mm 5-way jumper cable 5 way male to male adapter Quick Start User Guide
Note
Arduino MCU module is not included.
For new designs the 4D Systems gen4 range of LCD displays should be considered, including: • gen4-uLCD-24DT (RS part 1257941) • gen4-uLCD-28DT (RS part 1257942) • gen4-uLCD-32DT (RS part 1257943) • gen4-uLCD-43DT (RS part 1257947)
