FTDI Chip 500mm, Male USB to Female Receptacle, Serial Cable Assembly

  • RS庫存編號 741-7076
  • 製造零件編號 C232HM-DDHSL-0
  • 製造商 FTDI Chip
產品概覽和技術數據資料表
法例與合規
相容
產品詳細資訊

USB 2.0 Hi-Speed to MPSSE Cable, FTDI Chip

The USB 2.0 Hi-Speed to MPSSE cables contain a small internal electronic circuit board, utilising the FTDI FT232H, encapsulated into the USB connector end of the cable. This chip handles all the USB signalling and protocols. The cables provide a fast, simple way to connect devices with 3.3 or 5V digital interfaces to USB.

Based on the single chip USB Hi-Speed FT232H device
USB 2.0 Hi-Speed (480Mbits/Second) and Full Speed (12Mbits/Second) compatible
Entire USB protocol handled on the chip – No USB-specific firmware programming required
USB Type A connector for direct connection to a host or hub
USB bus powered
Fully assisted hardware or X-On / X-Off software handshaking
Synchronous Serial (MPSSE) data rates of up to 30Mbps on JTAG, SPI and I²C
1kByte receive and transmit buffers for high data throughput
Transmit and receive LED drive signals
Adjustable receive buffer timeout
Support for USB suspend and resume
Low operating and USB suspend current Low USB bandwidth consumption
UHCI / OHCI / EHCI host controller compatible
Operating temperature range: -40 to +85°C
Cable length: 1800mm
FTDI’s royalty-free D2XX drivers eliminate the requirement for USB driver development in most cases

規格
屬性
Connector A Male USB
Connector B Female Receptacle
Length 500mm
Cable Type USB
當前暫無庫存,可於02/03/2020發貨,6 工作日送達。
單價(不含稅) 個
TWD 776.00
(不含稅)
TWD 815.00
(含稅)
單位
Per unit
1 +
TWD776.00