Testec SI Series TT-SI 9010 Oscilloscope Probe, Active, Differential Type, 70MHz, 1:100, 1:1000, BNC Connector
- RS庫存編號:
- 512-6078
- 製造零件編號:
- TT-SI 9010
- 製造商:
- Testec
此圖片僅供參考,請參閲產品詳細資訊及規格
查看所有Oscilloscope Probes
法例與合規
不適用
- COO (Country of Origin):
- TW
產品詳細資訊
Testec 70MHz Active Differential Oscilloscope Probes
The Testec is an active differential oscilloscope probe that enables a conventional oscilloscope to display and measure in-circuit waveforms that are referenced to high common-mode voltages. It is capable of safely measuring differential voltages up to ±2500V AC and 7000V ac/dc. It supports bandwidths up to 70MHz.
This oscilloscope probe can measure signals below 700V by selecting the attenuation ration to 1:100.
This oscilloscope probe can measure signals below 700V by selecting the attenuation ration to 1:100.
Features and Benefits
Bandwidth is DC to 70MHz
Attenuation is 1:100/1:1000
Rise time is 5ns
Differential mode input voltage is 1:100 ±700V (DC+peak AC) or 700Vrms 1:1000 ±7000V (DC+peak AC) or 5000Vrms
Input impedance is 10Mohm ll10pF each side to ground
Common mode voltage range is 1:100 and 1:1000 ±7000V (DC+peak AC) or 2500Vrms
Non-destructive max. input voltage is 1:100 and 1:1000 ±7000V (DC+peak AC) or 2500Vrms
CMRR (typical) is -80dB at 50Hz and -60dB at 20kHz
Offset (typical) is <±5mV
Noise (typical) is 0.9mVRMS
Attenuation is 1:100/1:1000
Rise time is 5ns
Differential mode input voltage is 1:100 ±700V (DC+peak AC) or 700Vrms 1:1000 ±7000V (DC+peak AC) or 5000Vrms
Input impedance is 10Mohm ll10pF each side to ground
Common mode voltage range is 1:100 and 1:1000 ±7000V (DC+peak AC) or 2500Vrms
Non-destructive max. input voltage is 1:100 and 1:1000 ±7000V (DC+peak AC) or 2500Vrms
CMRR (typical) is -80dB at 50Hz and -60dB at 20kHz
Offset (typical) is <±5mV
Noise (typical) is 0.9mVRMS
Applications
Oscilloscope probes are used with oscilloscopes to enable the signals on the circuits being tested to be connected to the oscilloscope so that signals can be measured. These oscilloscope probes can be found in:
Performance conversion
Inverters
Motor speed indicators
Switch mode power supplies
Performance conversion
Inverters
Motor speed indicators
Switch mode power supplies
Certifications
CAT I 2500 VAC
CAT II 7000 VAC/DC
CAT II 7000 VAC/DC
Supplied with
Probe
4 x AA batteries
2 x Grabbers red & black
Instruction manual
Factory calibration certificate
4 x AA batteries
2 x Grabbers red & black
Instruction manual
Factory calibration certificate
規格
屬性 | 值 |
Probe Type | Active, Differential |
Attenuation | 1:100, 1:1000 |
Bandwidth | 70MHz |
Maximum Common Mode Input Voltage | 5kV |
Connector Type | BNC |
Model Number p | TT-SI 9010 |
Number of Probes | 1 |
Series | SI |
Safety Category | CAT I 2500 V, CAT II 7000V |
Rise Time | 5ns |
可供預購。
單價(不含稅) 個
TWD36,587.00
(不含稅)
TWD38,416.35
(含稅)
單位 | Per unit |
1 + | TWD36,587.00 |