Sauter HB0 100-0HB0 100-0. Durometer
- RS庫存編號:
- 136-3545
- 製造零件編號:
- HB0 100-0
- 製造商:
- Sauter
4 在6 工作日內發貨 (海外庫存)
10 在6 工作日內發貨 (海外庫存)
已增加
單價（不含稅） 個
TWD5,548.00
(不含稅)
TWD5,825.40
(含稅)
| 單位 | Per unit |
| 1 + | TWD5,548.00 |
- RS庫存編號:
- 136-3545
- 製造零件編號:
- HB0 100-0
- 製造商:
- Sauter
法例與合規
- COO (Country of Origin):
- CN
產品詳細資訊
Kern Analogue Shore Hardness Tester
A compact hand held durometer with drag indicator. Ideal for internal comparison measurement. Supplied in a wooden carrying case for safe and secure storage.
Typical Application
• Measurement of penetration (Shore)
Feature and Benefits
• Mechanical shore hardness meter
• For internal comparison measurement. Standard calibrations e.g. to DIN 53505 are often not possible because of narrow standard tolerances
• Shore A: Rubber, elastomers, neoprene, silicone, vinyl, soft plastics, felt, leather and similar material
• Shore D: Plastics, Formica, epoxies, plexi glass etc.
• Shore A0: Foam, sponge etc.
• Max Mode: Holds the maximum value in the display
• Point Mode: Shows one instant value
• Can be attached to test stands SAUTER TI-A0 (for Shore A and A0), TI-D. (for Shore D)
• Tester Shore A0
Parallels, Surface Finish & Hardness
Surface Finish
Any machined component has a surface geometry which consists of three basic elements:
Form or Curvature - Whether the surface has irregular bumps or dimensional changes
Waviness - Whether the surface has regular repetitive ripples or patterns (e.g. milling patterns)
Roughness - The shapes or irregularities that are smaller than, and form part of the waviness pattern (e.g. material micro-structure)
Waviness - Whether the surface has regular repetitive ripples or patterns (e.g. milling patterns)
Roughness - The shapes or irregularities that are smaller than, and form part of the waviness pattern (e.g. material micro-structure)
Waviness and roughness are traditionally the most difficult elements to measure when comparing surface finish, however, they have a radical effect on the performance of the finished component. Variations will cause aesthetic appearance changes, component wear variations, oil retention variation etc. Many manufacturers therefore specify a range of roughness values which their components should be manufactured to, often expressed as: Ra, Rq (RMS), RzDIN, Ry, Sm,mm.
規格
屬性 | 值 |
|---|---|
| Shore Scale | Shore A0 |
| Tester Type | Durometer |
| Indenter | Ball Head |
| Graduation | 1 |
| Weight | 160g |
| Dimensions L x W x D | 115 x 60 x 25mm |